How to Use FCOM Trouble Codes Freeze Frame Function

Posted on by VCDS

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

FCOM supports so called DTC Freeze frames. Every DTC is assigned variable set of environment data (such as mileage, battery voltage, engine speed, etc) at time of first DTC occurence. If multiple DTCs are present, ECU may record only first DTC freeze frame or only a subset of DTCs may contain freeze frame.

Please note that pre-UDS (ISO14229) ECU freeze frame is mostly limited only to petrol engines. All ISO14229 UDS ECUs usually support freeze frames. Freeze frame contents is determined by ECU for each DTC.

The article shows how to read freeze frame for fault codes stored in BCM ECU. Freeze frame is available only for the first DTC displayed.

Preparations:

FCOM Ford OBD2 Diagnostic Software Download

How to Install FCOM Diagnostic Software on Window/Linux

Procedures:

Plug your FCON interface to vehicle,then run FCOM software

Click

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: How to Use FCOM Trouble Codes Freeze Frame Function From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *