For BMW X-series X3_E83, when replacing steering angle sensor, fault code of 5EBE steering angle sensor implausible occurs. After checking or replacing the steering angle sensor, first set code for steering angle sensor, then enter ABS/DSC system to calibrate. Save current steering angle value as ZERO.
Another article:BMW X3 E83 Steering Angle Learning by Launch X431
And for more Launch X431 Test Case,check here:How to use Launch X431
Recode:
1.Select Coding/Program.
2.Select car model: Coding/Program, X-series -> X3_E83 Chassis.
3.Select Coding(Recoding).
4.Select corresponding system, such as LWS (steering angle sensor).
5.Steering angle sensor calibration.Select car model: Manually select: System select -> X-series -> X3_E83 Chassis, automatically read out: vehicle identification -> automatic identification -> system scan.
6.Enter ABS (Anti-lock Brake System – DSC) system.
7.Read DTC.
8.Clear DTC.
9.Select Special Function
10.Enter “Steering angle learning”.
11.Follow the software prompts. After successful calibration, it prompts as below:
Fault in the steering angle sensor memory will be automatically deleted after successful calibration.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: cat Launch Launch X431 X431
Related Posts
PACCAR Truck Rear Drive Axle Oil Temperature Gauge Inoperative Repair
2023.04.3
How to Repair Lexus LX570 AB60F Transmission Clutch/Brake Damage
2020.09.16
How to use Scania SOPS +XML Editor Change Speed Limit
2019.07.24
John Deere Service Advisor 5.3.225 (replaces 5.2) Offline 2023 Construction and ...
2024.01.28
How to Solve Autocom Delphi Firmware Update Fail Error
2019.02.24
OPCOM Program Immobilizer I II Keys for Opel Guide
2019.06.17
Carprog Read MC68HC05 Processor Guide
2019.02.24
How to use GM Tech2 Scanner GM Diagnostic Tool
2024.01.28
What’s the Features Of SmartPRO 5000U-Plus Programmer
2023.06.10
How to Install & Setup Original wiTECH Diagnostic Extender
2019.07.24