VCP System Basic Setting for VW Audi Xenon Headlight Beam Height Control

Posted on by VCDS
On Sale: Scania VCI3 US$89.00, SmartPRO 5000U-PLUS Programmer US$2190.

This instructions show a guide on how to use VCP system to perform basic setting for VW Xenon headlamp beam height.

Preparations:

How to Install VCP System Diagnostic Tool Software

VCP System Professional Diagnostic Tool Software Download

Vehicle Models Supported：

PQ35/46: Passat 3C, Audi A6 4F, Audi A8 4E

K-Line: Passat 3B, Audi A4 4E, Audi A6 4B

CAN UDS: A6 C7 / A8 D4

Procedures:

Connect your VCP interface to vehicle,then select “Xenon” and “Basic setting of Xenon range controller”

VCP System Basic Setting for VW Audi Xenon Headlight Beam Height Control (1)

The procedure sets the Xenon headlights in the service position,so that they could be manually set.

Conditions:

Ignition on

The engine NOT running

VCP System Basic Setting for VW Audi Xenon Headlight Beam Height Control (2)

Now you need to select your vehicle models

Then click “Next” to start processing

VCP System Basic Setting for VW Audi Xenon Headlight Beam Height Control (3)

Done!

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: VCP System Basic Setting for VW Audi Xenon Headlight Beam Height Control From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *