This instruction show the steps on how to use FCOM to re-configuration of an ECU using AS-BUILT data function for Ford Focus 2008.
Preparations:
FCOM Ford OBD2 Diagnostic Software Download
How to Install FCOM Diagnostic Software on Window/Linux
Procedures:
Connect FCOM interface to vehicle OBD port,then run FCOM software
Click “Select Control Unit”
Select “IPC-Instruments panel cluster”
Select “Configuration” under “Expert functions”
Select “As-Built data”,then click”Go” to continue
Select “720-01-01,2C69 0040 807E”,then click “Exit”
Here input “CD7201408029”
Click “Write configuration to ECU”
It will show below warning massage,click “Yes” to continue
Reprogramming successfully
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!