This instruction show you guide on how to solve Scania truck articulation control system ACS 10 end position sensor fault codes.
Related Contents:
2024.04 Scania SDP3 V2.60.1 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2024 2018 Scania Multi EPC Parts Catalogue Free Download
End position sensor, ACS
Error identification
The end position sensor is activated even though vehicle speed is so high that the articulation unit should be relatively straight.
Cause
Defective end position sensor.
Short circuit or open circuit on the end position sensor circuit.
The plate which activates the end position sensor is deformed or has been moved out of position.
Notes
The ACS warning indication is displayed. Limp home mode will be activated.
Action
Check the end position sensor.
Check cable harnesses, harness-to-harness and harness-to-component connectors.
Check whether the plate which activates the end position sensor is deformed or has been moved out of position.
For more information about Scania truck,please refer to:Scania Trouble Repair.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!