There is some latitude to relocate signals to different connector locations on the BC / ESC and the Remote Power Modules. This capability is limited to relocations that are configurable and are permitted by your DLB programming level.
Preparation:
Navistar Diamond Logic Builder (DLB) Free Download
How to Install Navistar Diamond Logic Builder (DLB) Software
DLB will generate an error message if you try to move something where is not permitted.
To move a signal:
1.Drag and drop the desired signal from its current location to a vacant location.
2.Save changes by doing one of the following:
- In the menu bar, select File > Save.
- In the toolbar, click the Save icon.
3.Program the changes into the vehicle.
Errors
If you do not have sufficient permissions to make the change, the following error will be displayed.
If you try to change pin assignments on a template, the following message appears.
Additionally, new messages that advise why the move is generating an error may appear on the Messages Tab.
Use Default
The Use Default option in the Edit Menu will return connector pin mapping, parameter values or switch and gauge locations to the default settings. This can be helpful when configuration conflicts occur. Use this carefully and be sure to compare anything that might have changed in the DLB interface to your desired configuration.
NOTE–Using the Default Pin Mapping function may undo any custom pin locations.
NOTE–Using the Default All option may help to clear an error message that shows up in the Messages tab. Use caution to ensure that any undesired changes were not made.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!