Here is the instruction show you guide on how to use Launch X431 X-PROG3 to clone Volkswagen MG1CA811 ECU.
Device You Need:
Launch X431 X-PROG3 (Amazon shop)
Run X-PROG3 PC Adaptor software
Enter “MG1CA8” to search ECU
Click “Direct connection of diagram”
Now follow the diagram to build connection wire on ECU MG1CA811
After wire connection build,please click “Connect”
Then click “Read EEPROM data”
After EEPROM data reading processing done,save the EEPROM data on your PC
Click “Read FLASH data”,then save it on your PC
After then click “Disconnect” button
Then get another new/used ECU MG1CA811 to connect to Launch X431 X-PROG3
Also use “Read EEPROM data” and “Read FLASH data” to make backup files firstly
After then use “Write EEPROM data” and “Write FLASH data” to write the EEPROM and FLASH files that you save from original ECU MG1CA811 to the new/used ECU MG1CA811.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!