This article show a guide on how to use VCDS to remove/solve Audi MMI “03276 PLEASE CHECK SOFTWAE VERSION MANAGEMENT” Error Massage.
Preparations:
VCDS 17.8.1 Full+Loader V2/V4 Free Download
Note:For more about Audi MMI Repair articles,please check:Audi MMI Repair,and more VCDS projects check:VW VCDS Projects
Procedures:
Open VCDS and inside “Select Control Module” click on “Select” button
Select module “5F”
Click on “Adaption – 10”
Enter “15” for the channel and press the “Read” button
Copy the number in “Count” field
Using a scientific calculator make the next formula:
YourCountNumber ^ 51666
Or
YourCountNumber XOR 51666
Now enter the result into the “New Value” field and click “Test” and “Save”
Note that only “Save” may be available in which case you would ignore the “Test” button
Exit Adaptations and return to the main screen (Click “Done, Go Back)
Click “Fault Codes – 02”
If you see any Faults click “Clear Codes – 05” then “Done, Go Back”
Now check Fault Codes one more time and the SVM error should be gone. If not, repeat the steps again.
Info: In the event you go to Channel 15 and there is no Count value, clear your errors and then go back recheck. Sometimes the count will not be present until the error is cleared. Of course the error will return until you complete all the above steps again,more information click here
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!