VCDS VAG COM Program Add New Keys for Audi A4 2001-2008

In this DIY guide,I will show you the procedures on how to use VCDS to do Audi A4 2001-2008 new key programming (need working key). Preparations: VCDS 17.8.1 Full+Loader V2/V4 Free Download How to Configure VCDS & Diagnostic Cable for Your Laptop How to Set Up VCDS Work on USBASP Programmer Procedures: Use working key turn the ignition on,then plug VCDS interface to vehicle obd port.

Run VCDS software,and select “Select Control Module”

Select “46-Central Conv”

After controller information reading,select “Adaptation 10”

Select “Read”àclick “Save” buttonàClick “Yes” to save

Change channel value to “21”,and select new value to “1”,and click “Test” button

Now pree “lock” button on you new remote fob,the VCDS will show the “Adjustment” to ”Recognized”

Now save the value

After you saving value,click read button again And change new value “2”,and click “Test” button

Press the “Lock” button of the working key that you insert in ignition Adjustment-à”Recognized”

Now click to save value again

Go back and close controller

Now test both keys,both of them can work normally.

Done! This post is from China OBD2, Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. The main popular diagnostic tools for workshop are:Vag COM, VAS5054A, GM Tech2, iProg+ Programmer, Orange 5 programmer, Scania VCI3, etc. This Post: VCDS VAG COM Program Add New Keys for Audi A4 2001-2008 From ChinaOBD2 Official Blog
Please keep this link if you copy the post!