Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here is an illustration show you guide on how to solve Scania truck auxiliary heater system overheating error ATA 114.
Related Contents:
2024.03 Scania SDP3 V2.59.2 V2.40 Diagnostic Software Free Download
2023 2018 Scania Multi EPC Parts Catalogue Free Download
Scania VCI3 Diagnostic Adapter Full Chips
Overheating
Error identification
The difference in temperature between the temperature sensor and overheat sensor is too great.
Cause
Blocked air supply to the auxiliary heater, cold air.
Blocked air vent from the auxiliary heater, heated air.
Faulty flame monitor or control unit.
Check the fuel supply.
Notes
Action
Check the fuel supply.
Check that the pipes for air supply or air venting are not blocked.
Check the flame monitor.
Check the overheat sensor.
Instructions for the checking procedures are found in the work description in Multi under 18-90
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!