Renault Megane IV 2015+ Key Programming by Zed-Full

This article will show you guide on how to use Zed-Full immobilizer solution to program keys for Renault Megane IV 2015+.

Procedures:

Locate OBD port,and plug Zed-Full to OBD port

Enter menu to select “OBD Application”

Select “Renault”

Now select “Megane”,then click “Continue” button

Select “Megane 4 15+”,click “Continue” button

Select “Card key”

For this Renault key programming,it will cost your credits,massage show as below,click “Yes” to continue

Enter total key count to have at the end of the procedure.

Turn ignition off,press “Start/Stop” button,also open driver side door

It will take you about 2 minutes to checking flash data,please wait

Press “Continue” button to precode new key to be programmed

Place new key into Zed-Full antenna and press “Continue” button

It will prompt you “Would you like to pre-code” another transponder?

Click “Not” to continue

Then place new key to be programmed to “Start/Stop” button on car and press “”Continue button

Successful

Now we place original working key to “Start/Stop” button on car and press “Continue” button

Successful

Now please wait. Saving log…it will take about 1 minutes

Now you can test all keys on your car.

This post is from China OBD2, Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. The main popular diagnostic tools for workshop are:Vag COM, VAS5054A, GM Tech2, iProg+ Programmer, Orange 5 programmer, Scania VCI3, etc.

This Post: Renault Megane IV 2015+ Key Programming by Zed-Full From ChinaOBD2 Official Blog
Please keep this link if you copy the post!