Mercedes Benz W204 Fottwell Temperature Sensor Replacement

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

There are several temperature sensors both inside and outside your Mercedes that work together to result in a properly functioning climate control system. Depending on how your vehicle was optioned and depending on the error codes you are getting you may need to replace the footwell temperature sensors.

Applies to:C350 (2007-14), C180 (2007-14), C200 (2007-14), C230 (2007-14), C250 (2007-14), C280 (2007-14), C300 (2007-14), C320 (2007-14)

Parts Required: Sensor

Hot Tip: Place a cloth under the filter when removing

Performance Gain: Functioning climate control

Complementary Modification: Change the cabin air filter

Procedures:

The footwell temperature sensors are located in the footwell kick or cover plates.The procedures are the same for both sides.To access it you must first remove the kick panel or protective piece that is up under the dash.Use a T20 Torx and remove the three screws holding it in place (red arrows) and pivot it down at the front.

Disconnect the electrical connection for the footwell light (red arrow).

Pull out the connection for the footwell temperature sensor (red arrow)

You can now slide the piece all the way down and then pull it out.The sensor is located inside the air duct closest to the center (red arrow)

This photo illustrates how the electrical connection base of the sensor (red arrow) sits outside of the airflow and is held in place by a rubber grommet at the base.