This instruction show you guide on how to solve JCB StageV Tier4 engine air filter pressure sensor active at init state SPN 107,FMI 31.
Related Contents:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2017 JCB Parts Plus+ and Repair Service Manual Free Download
2023 JCB ServiceMaster 4 Free Download for Win 7/Win 8/Win 10
Description
The air filter pressure sensor indicates blocked filter even though engine is not running.
Possible causes are:
The air filter pressure sensor wiring is defective.
The air filter sensor is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. The CAN message indicates active fault.
Solution
First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the air filter pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).
Check the operation with another air filter pressure sensor to see if the air filter pressure sensor is defective.
More repair case for JCB,please refer to:JCB Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
Scania SOPS File Encryptor/Decryptor +XML Editor Download
2019.12.15
JDiag JD301 OBD2 Scanner Automotive Engine Fault Code Reader CAN Diagnostic Scan...
2018.12.17
VAG506M Code Reader Support TP-CAN and New UDS Protocol
2018.12.17
2 steps to test and repalce ABS Fuse
2019.02.24
FUSO Truck Engine ECU Reprogramming by Xentry
2023.05.10
For MAN Diagnostic Tool MAN CAT T200
2018.12.17
How to Do DPF Regen on 2012 VW Passat TDI with Launch X431 Pro5
2024.01.28
Test the Connection to the Vehicle using NEXIQ Device Tester
2024.01.28
Iveco AlphaNumeric Code Calculator v0.1 Free Download
2019.05.14
Opel Vehicle Data Link Connector Location Collection
2019.05.31