Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
One common issue that some customers have encountered when using the Godiag Full Protocol OBD2 Jumper with the OBDSTAR P50 is the failure to read data and the appearance of a communication error. This can be frustrating and may lead to doubts about the functionality of the Godiag Jumper. However, there are a few simple solutions to solve this problem.
Here is the solution.
Just connect CAN H and CAN L cable of Godiag OBD2 jumper via one electrical resistance (120 ohm resistor), then the problem will be solved. The Electrical resistances can be found in the Godiag Breakout Tricore Cable package. There are three in all.
Finally, the customer gave feedback below.
Thanks so much! I tried it and worked fine!
It
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
Bobcat 3450 Utility Vehicle Fuel Injector Removal and Installation Guide
2023.04.6
SmartPRO 5000U-PLUS 5000u Plus Universal USB Programmer PCF29XX Chips Support Li...
2023.06.7
How to Update Original & Crack wiTech Chrysler Diagnostic Software
2019.07.24
How to Solve SVCI 2020
2020.01.4
How to connect WIFI for BMW ICOM
2024.01.24
BMW E90 E91 E92 E60 E61 E63 E64 CBS Reset Guide
2019.03.25
Detroit GHG14 Engine DOC Inlet Temperature Unable to Reach HC Dosing Solution
2023.06.13
How to Associate microPODs to Service Technicians at CJDR + FA Dealerships
2019.06.17
Promotion Autel Original MaxiCOM MK808 Diagnostic Tool 7-inch LCD Touch Screen S...
2019.02.17
UPA Programmer & NYO 4.0 Change Mileage for Renault ESPACE HC908AZ60
2020.10.11