How to Remove and Install DC Converter for Volvo EC18 Electric

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

This instruction show you guide on how to remove and install DC converter for Volvo EC18 Electric machine.

 

Preparations:

Volvo Prosis 2023 2022 2019 Free Download

Volvo Techtool 2023 Diagnostic Software

Volvo VOCOM 88890300

 

Procedures:

Removal

1.Place machine in the service position.

2.Decommission the machine.

3.Remove the cab platform.

4.Disconnect the remaining cables on the DC/DC converter.

5.Remove the nuts securing the DC/DC converter on the bracket.

Figure 1
1.DC/DC converter

2.Nuts (4 pcs)

3.DC/DC converter

4.Bracket

 

Installation:

Total procedure time (hr): 1.25

1Install the DC/DC converter on the bracket.

Figure 1
DC/DC Converter

1.Nuts (4 pcs)

2.DC/DC converter

3.Bracket

 

2.Install the cable from the front ground point on the terminal post (3) with recommended torque.

Figure 2
DC/DC converter

1.Terminal post, positive (+) input voltage

2.Terminal post, ground input voltage

3.Terminal post, ground output voltage

4.Connector

 

3.Install the cable from the rear ground point on the terminal post (2). Tighten the nut with recommended torque.

4.Install the positive (+) cable on the terminal post (1). Tighten the nut with recommended torque.

5.Connect the cable (4) of the wire harness to the DC/DC converter.

6.Install the cab platform.

7.Check the electrical installation of the DC/DC converter according to Insulation resistance and low resistance measurement, checking.

 

For more Volvo excavator repair,please refer to Volvo excavator trouble repair

 

This Post: How to Remove and Install DC Converter for Volvo EC18 Electric From ChinaOBD2 Official Blog
Please keep this link if you copy the post!