This is a guide to using Launch X431 Pad VII to perform new ECM(Engine Control Module) VIN registration for a 2017 Nissan X-Trail T32. It’s very helpful for ECM replacement in vehicle repair.
Procedure
Nissan Latest version >> Full system diagnosis >> The vehicle with 16PIN >> System selection >> Engine >> ECM(Engine Control Module)
X-431 Pad7 is scanning ECU… please wait
Special function >> VIN registration
Confirm the ignition switch is on and the engine stopped.
Hold these conditions during this procedure.
Touch start.
As we can see, the VIN/Chassis value is blank now.
VIN Read >> Input
Input the VIN of the vehicle. Refer to S/M for the location of the identification plate.
Write >> Input
Input VIN once again.
Press “Start”.
Command succeeded.
Turn the ignition switch off for 10s, then the ignition switch on to confirm no DTC.
Exit to enter into “VIN registration” again.
The VIN/Chassis value was displayed, which means the VIN number has already been registered successfully.
Done.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: cat Launch Launch X431 Nissan X431
Related Posts
Toyota Techstream v16.00.017 + Activation 02.2021 Free Download
2021.02.18
Automatic V8/X6 Key Cutting Machine User Manual
2018.12.24
How To Do GM Control Module Programming With Multiple Diagnostic Interface (MDI/...
2019.12.16
What’s the Features Of SmartPRO 5000U-Plus Programmer
2023.06.10
How to Access JLR SDD Engineering Mode (Seed Key)
2023.04.4
Bosch ADS625 Wiring Diagram Function Test on Nissan Titan 2015
2019.06.10
How to Install & Setup Original wiTECH Diagnostic Extender
2019.07.24
How to Install Original Mercedes BENZ EPC/WIS/ASRA net |China OBD2 Store
2019.02.23
Hitachi ZX890-7 Excavator Aftertreatment Device Serial No. Rewrite Guide
2023.04.3
Doosan ISUZU 6UZ1 Engine Lost Communication with TCM U0101 Solution
2023.04.17