This mini post show a guide on how to use Delphi DS150 to diagnose Audi A3 2009 to check CAN communication gateway real-time data.And you can check the video guide at end of article.
What You Need?
Guide:How to Install Delphi DS150E 2015.R3 Software
Autocom DELPHI DS150E Cars & Trucks Software Free Download
More Delphi DS150E Project Here:Delphi DS150E Test Cases
Procedures:
Connect Delphi DS150E interface to vehicle,then run Delphi DS150E software
[Audi]–>[A3]–>[2009]–>[Multifunction]–>[Gateway]–>[Diagnose],then click “OBD” button at right low corner.
Click [OK] to continue
Choose function by using the buttons in the left menu
Tip:
Move the mouse pointer over the buttons to see a hint describing the function
Click “Real-time data” button
Now the Real-time data show as below:
It show from “Data list 1” to “Data list 2”….
You can click “Next” button to view more control module status
Transport mode
CAN:communication,gateway
Done!
If you need to know more about DS150, can click here…
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!