This illustration show the steps on how to remove and install hydraulic power unit for Bobcat 3450 Utility Vehicle.
Related Contents:
Bobcat 3450 Utility Vehicle Fuel Injector Removal and Installation Guide
Bobcat Service Analyzer 90.00 89.06 Diagnostic Software Free Download
Procedures:
Remove the cargo box.
Lower the lift arm and stop the engine.
Relieve the pressure from the hydraulic system.
Disconnect the negative (-) cable from the battery
Important:
When repairing hydrostatic and hydraulic systems,clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses,tubelines and ports to keep dirt out. Dirt can quicklydamage the system.
Warning:
Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil.Failure to use care around combustibles can cause explosion or fire.
Disconnect the solenoid connector (Item 1) from the main harness.
Move the rear gear case breather hose (Item 2) out of the way
Disconnect the hose (Item 1) from the top of the control valve.
Disconnect the hose (Item 2) from the side of the control valve.
NOTE: Mark all hoses and coils for proper location identification before removal.
Disconnect the hoses (Item 1) from the bottom of the control valve.
Slide the boot (Item 1) back and remove the nut (Item 2) which secures the positive cable to the solenoid.
Remove the positive cable (Item 3) from the solenoid.
Remove the ground bolt (Item 4) and move the wires out of the way
Remove the nut (Item 1) and disconnect the wire (Item 2) from the solenoid.
Disconnect the auxiliary solenoid harness connector (Item 3) from the main harness (if equipped).
Remove the hoses (Item 1) from the auxiliary valve (if equipped).
Remove the two bolts (Item 1) from the bottom of the hydraulic power unit.
Remove the hydraulic power unit (Item 2) from the vehicle.
More repair topic for Bobcat,please refer to:Bobcat Excavator Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: cat
Related Posts
How to add 2018 Dodge Challenger with Autel IM608 Pro
2024.01.28
Free Download Op-com Can OBD2 FW 1.99 Opel Diagnostic Tool
2019.03.6
Renault CAN Clip V195 and Consult 3 III For Nissan Professional Diagnostic Tool ...
2020.07.14
Best Quality VCM II Diagnostic Tool With WIFI Function for Ford V98
2018.12.17
How to Setup Zed-NET for Zed-Full for Internet Work
2019.07.24
How to Install Scania VCI3 Diagnostic and Programming Software Scania SDP3
2019.12.15
Newest Super SBB2 Key Programmer Oil/service Reset/TPMS/EPS/BMS Handheld Scanner
2018.12.17
SmartPRO 5000U-PLUS Programmer NXP Chips Support List
2023.06.9
SsangYong EPC Parts Catalog Free Download
2019.07.26
How to do an Oil Change for Toyota Camry 2005-2010 by Yourself
2019.07.27