2 steps to test and repalce ABS Fuse

Posted on by VCDS

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

If you see ABS warning light on,what will you do?Drive you car to garage or do it youself?I recommend the first thing you should check the ABS fuse,just to use of a simple test light.

ABS system the same as any other electrical system and is protected by a fuse that can blow if an electrical surge or short circuit occurs.ABS pump motor or controller get in trouble when short circuit occurs.

 

How to locate the ABS fuses?

Usually,most ABS fuses are located in the fuse panel under the dash or in the power distribution center under the hood.Consult your car

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: 2 steps to test and repalce ABS Fuse From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *