Manual: How to do GM Tech 2 clone scanner self test step-by-step
VCI self test
Keypad self test
CANdi self test
RS-232 self test
Follow the instruction in detail…
Part 1: Tech2 VCI self test
Insert the GM card
Connect the adapter and ready for the self test
Go to the main menu and select F4: Tool options
F3: Self test
Exit to continue
Select the function for self test
Here, press F2: Automated VCI
The VCI module self test result
Passed VCI selftest.
Part 2: GM Tech II Keypad self test
Go to the Tech 2 menu and select F4: Tool options
Then F3: Self test
Before running the Tech 2 self test:
(1) Candi cannot be connected
(2) Aldl loopback should be connected (GM3000109)
(3) Failure to follow these instructions may invalidate the self test
F3: Selectable main pcb
Press Keypad
And press key
Note: In the last image, the actual key pressed is F0 and the final result is PASS – that’s normal
When you test the keypad, press F0-F1-F2-F3-F4-F5-F6-F7-F8-F9-EXIT-ENTER-in a good order! DO NOT SKIP ANY ONE.
Part 3: Tech 2 scan tool CANDI module self test
VERY IMPORTANT: Pls make sure of the connection of the OBD adapter, OBD main cable, CANdi module, Tech 2 scan tool and the power supply — ALL should be good
The power should be connected by the OBD port for CANdi self test.
F4: Tool options
F7: CANdi diagnostics
F0: POST result
Test status
F1: Self test
CANdi self test result
Pass selftest
There are two test results for CANdi module.
The one is Figure 8, and the other is Figure 10.
Part 4: GM Tech2 scanner RS232 self test
Check the connection before R232 self test
F4: Tool options
F3: Self test
Exit to continue
F3: Selectable main PCB
F2: Rs-232 loopback
Rs232 test: Passed!
GM Tech 2 scanner tech support from https://www.chinaobd2.com/
This post is from China OBD2, Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!