How to Use Zed-Full Program Keys for Fiat Egea by OBD

This article show you the guide on how to use Zed-Full immobilizer solution to program Fiat Egea keys by OBD.

Procedures:

Connect Zed-Full to Fiat Egea obd port

Enter menu to select “OBD Application”–>”Fiat”–>”Fiat EU”

Select “Immobiliser”,then press “Continue”

Select “Pre-coding chip”,click “Continue”

Only “BSI Type1” installed vehicles are supported.

BSI type can be checked from BSI label and it is as shown picture below

Select “Delphi Meg AES chip NEC MCU”

It need cost your credits,click “Yes” to continue

Turn ignition “ON”,then click ”Continue”

Please wait,it will cost about 2 minutes to proceed

Connection is successful.

Now Zed-Full show you with the vehicle immobilizer system info as below

Car VIN number,pin code and key ID(s) will be shown on Zed-Full screen

New key to be programmed must be pre-code first,click “Continue”

This step need cost credits,click “Yes” to continue

Put new key to be programmed to Zed-Full antenna and press “Continue” button

Now it will start pre-coding the transponder

Wait..it show you as below Pre-code written

Now we click “No” to exit transponder precoding procedure

Press “Continue” button to program precoded transponder to the vehicle

All non-programmed working keys will be erased from car memory irreversibly and can not be programmed again.Click “Continue”

Car has “2” working keys,we will add “1” key,so we enter “3” as total key quantity.

Working key was already on ignition and ignition was “ON”,press “Continue” button

First key is on ignition,press “Continue” button

Now put 2^nd key to ignition and turn ignition on,then click “Continue”

Then Zed-Full prompt you to put 3^rd key to ignition and turn ignition on,click “Continue” button

Now you have programmed 3 keys for your Fiat Egea.

Test 3 keys on your vehicle.

This post is from China OBD2, Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. The main popular diagnostic tools for workshop are:Vag COM, VAS5054A, GM Tech2, iProg+ Programmer, Orange 5 programmer, Scania VCI3, etc.

This Post: How to Use Zed-Full Program Keys for Fiat Egea by OBD From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags: Car Key Programmer cat Code Reader ECU Chip Tunning gm immo iprog key Key Pro OBD2 original program Scania VCI vci wholesale

Related Posts

MPPS V22 V21 V18 V16 ECU Programming Software Free Download

2019.08.14

How to Set I/M Set for Chrysler Vehicles

2019.06.17

Volvo PTT Export Sensor Values to Excel for Pre-2013OBD

2019.07.24

Best VXDIAG VCX Nano OBD2 Scanners Review

2019.05.14

Autel MaxiCheck DPF Reset Special Application Diagnostics Update Online

2018.12.17

(Solved) PCM Flash Crack Error: USB dongle is not available

2019.03.15

MB-PRO IR Code Reader For Mercedes Benz

2018.12.17

DIY:How to Remove ECU for Toyota FT86

2019.05.31

JETI ForkLift (Jungheinrich Judit) Free Download

2019.05.14

2019 Latest ATMEGA64 Repair Chip Update Software for XPROG-M Programmer V5.0/V5....

2019.02.26