Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here comes some feedback about Xhorse Multi–Prog Programmer.
1.Read BMW Bosch MEVD17.2.9 ECU ISN/EEPROM/Flash on bench-OK
Run Multi-Prog software on a computer (Win7/Win10/Win11 are ok)
Select Device>> ECU>> BMW>> BMW_BOSCH_MEVD17.2.9_Fxx (N20)>> OK
Click “Detail” to check the connection diagram
Connect Multi-prog and BMW ECU via Multi-Prog ECU Adapter and ECU harness plug correctly
Connect the device to the computer via a USB cable
Supply power to the device and turn on the host switch
Read ISN successfully
Read INT EEPROM and INT FLASH data in sequence and save the corresponding data
Everything works fine!
2.Read Benz MED17. 7.2 on bench- OK
Xhorse Multi Prog and Benz ECU connection
Read INT FLASH-OK
Read INT EEPROM-OK
3.Clone BENZ 271de ECU on bench- OK
4.Read Peugeot MEV17.4.2 TC1767 INT EEPROM/FLASH in boot mode-OK
Read also:
Xhorse Multi-Prog User Guide:
Xhorse Multi-Prog Software & Device Driver installation guide:
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!