Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Xhorse Masker Garage Remote Tutorials: code deleting, remote cloning, frequency setting and data recovery.
What is on Xhorse Masker Garage Remote?
Slide download the cover, you can see the LED light, “UP” button, “Down” button, “Lock” button and “Pause” button.
How to delete code with Masker Garage Remote?
Before remote cloning, we need to check the status of the remote to make sure the code is deleted.
As long as you keep pressing any key button, the LED light is always on, which means that the code has not been deleted.
Steps to delete code:
Press and hold “Up” buttonand “Down” buttons, and you can see the LED light turns on.
When the light turns off, release the buttons.
Press and hold “Pause” button until the light goes off, then release the button.
The light will flash once then go out quickly when we press any button of the remote. It means the code is deleted.
How to clone remote with Masker Garage Remote Key?
In case the remote cloning failed or the remote is working but its working distance is too short, please make sure the frequency of the remote is the same as the original one.
Steps to clone remote:
Press and hold any button, and the remote will enter cloning mode.
The LED light will flash, and then go out.
Put the original remote next to the Masker, then press and hold the same button on both remotes. Once the light is on, the current button is successfully cloned
Follow the steps to clone all buttons one by one.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!