Xhorse Dolphin XP005L and Key Reader Cut Fiat F500 Key

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

How to cut a Fiat F500 car key with Xhorse Dolphin XP-005L Key Cutting Machine and Xhorse Key Reader? Check the step-by-step guide below.

Step 1: Connect Dolphin XP005L and Xhorse Key Reader

Turn on XP-005L, select Database>> F>> Fiat>> 500

Put the original key on the clamp and tighten it

Select “Optical Identification”

Connect Dolphin XP-005L and Key Reader via Bluetooth

Step 2: Identify Key

It’s very useful to measure car key teeth with Key Reader.

Put the original key into the Key Reader

It identifies the key automatically, and shows the result on XP005L key cutting machine

Step 3: Cut key

Put a new key on the clamp of Xhorse key cutting machine and tighten it

Press “Start cutting” to cut the key

After cutting one side, continue to cut another side of the key

Cut key successfully

Clean the key. It is the same as the original key. Works fine!

This Post: Xhorse Dolphin XP005L and Key Reader Cut Fiat F500 Key From ChinaOBD2 Official Blog
Please keep this link if you copy the post!