Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Sometimes winkfp error 211 occurs when you flashing a module,and flashen is aborted.Here I write this article to share you with solutions of how to solve WinKFP error 211.
Below picture show the WinKFP error 211.
Here I collect possible reasons,you need to check one by one.
1.Check WinKFP Configuration,and make sure you have configured it as below picture shows.
2.You need to reprogrammed mdules on the MOST bus by ICOM.If you use K+DCAN cable to reprograme,it maybe occur 211 error.
3.Just code both modules to default. You can use any profile which has manipulation disabled.
4.Make sure your car plugged to power supply to maintain proper voltage.
5.You need to code both units and then align.This can be done via ncs and inpa.When units are virgin chassis is written at time of coding.
6.Below show two config files,please replace those two files(backup yours) with those and try whether it is working.(before repalcing,pls save your original files)
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: CAN cable original program
Related Posts
VIDA 2014D Read & Clear DTCs for Volvo XC90 2005
2019.07.26
How to Reflash CARPROG MCU AT91SAM7S256 Step by Step
2019.02.24
How to Use Cummins Insite Perform A ECM Calibration Download
2020.06.20
How to do BMW engine re-adaptation using ISTA D or ISTA+
2019.12.26
BMW E60 CIC Video in Motion Coding by Expert & NCSdummy
2019.06.17
W215 2003 K-line diagnosis: DTS Monaco or Vediamo
2019.03.7
Only US$155.00 NEXIQ USB Link Truck Scanner tool for Vietnam Valid untill 2019/2...
2019.02.18
Jeep Cherokee RKE Remote Keyless Entry Programming by Launch X431
2019.03.25
XPROG V6.12 vs. XPROG V5.84: adds new adapters / authorization, new PCB
2019.12.13
Toyota Corolla 2013+ Keyless Go All Keys Lost Programming by Zed-Full
2019.07.31