Which Xhorse Dolphin XP005L Milling Cutter is the Most Often Used? 1.5, 2.0 or 2.5mm

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Customer problem:

I’ve always used the 1.5mm cutter on my dolphin 2 xp005l but want to use a bigger cutter (2.5mm).

Does it cope well enough with most blade cuts or are there some keys that need the detail of a 1.5mm cutter?

Thanks!

The users’ practical suggestions:

@Michael Chandler

I don’t use the 2 or 2.5 anymore… The 1.5 takes a little longer to cut. But for me the 1.5 cuts a perfect security track key.

@Ron Walker

We have 6 dolphins and only use 1.5. As has been said, takes a little longer, however it does best all around job.

@Padraig O Murchu

I used 2.5mm for everything except VW HU162 keys and not had any problems.

@Wire Works

I’ve always used the 1.5. The 2.5 seems to cut too rough.

@Dale Nelson

1.5, I learned the hard way as a rookie of course…..

@Wood family locksmithing

I use the 2mm most.

@Boyd Beattie

Just stick to 1.5 unless you only do one or two types and can get away with a bigger blade. If you think it’s too slow, buy a Godzilla.

In conclusion, 1.5mm milling cutter is the most often used to work with Xhorse Dolphin II XP-005L key cutting machine.

This Post: Which Xhorse Dolphin XP005L Milling Cutter is the Most Often Used? 1.5, 2.0 or 2.5mm From ChinaOBD2 Official Blog
Please keep this link if you copy the post!