How to use Xhorse VVDI2 Key Programmer to swap cluster to bigger screen & transfer Immo data on a Skoda Octavia car?
Step 1.Read and Back up EEPROM & IMMO data of original cluster
Connect VVDI2 programmer to the vehicle and computer correctly
Run VVDI2 software
Select SKODA>> Key Learn>> 4th Immobilizer system VW/Skoda/Seat>> Instrument with Micronas CDC3217/3297/3272+24C32
First, read EEPROM/Flash
Save the original data after reading.
Then, read Immo data
Save the original Immo data after reading as well.
Step 2.Read and Back up EEPROM & IMMO data of new cluster
Install a new instrument with bigger screen into the vehicle, then use VVDI2 key programmer to connect
Use the same steps as step 1 to read and backup EEPROM/Flash and IMMO data in sequence
Step 3.Write original Immo data to new cluster
Load the original immo data file to write
Write data successfully.
Reset instrument with VVDI2 after all operation is finished.
Finally, start the car, running good!
Done!
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!