Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show you guide on how to remove rear crankshaft seal for Scania C,K series truck with 7 litre engine.
Related Contents:
2022 Scania SDP3 V2.53.2 V2.40 Diagnostic Software Free Download
2023 2018 Scania Multi EPC Parts Catalogue Free Download
Procedures:
Assembly tool (3164660)
The illustrations below show how to seal the crankshaft; the principle also applies to other procedures.
1 Clean the crankshaft and flywheel housing sealing surface with a lint-free cloth. The surfaces must be oil-free.
2 Inspect the surface of the crankshaft. If there are wear grooves deeper than 0.25 mm, use a sleeve and an oversize seal.
3 To facilitate installation of the crankshaft seal, the surface of the seal (A) can be lubricated with soap.
4 The plastic ring (B) should remain on the seal during fitting to protect the seal.
5 Fit the seal with the plastic ring over the crankshaft and press by hand towards the flywheel housing.
6 Fit the inner part of 2 300 541 Assembly tool (3164660) to the crankshaft flange. Screw on the outer part of the tool. Use a ratchet handle to turn the tool anti-clockwise and press down the crankshaft seal.
7 Remove 2 300 541 Assembly tool (3164660) from the crankshaft.
For more information about Scania truck,please refer to:Scania Trouble Repair.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!