Perkins 1106D Generation E362 Engine Overspeed Error Solution

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Perkins 1106D engine overspeed error always caused by speed above the trip point of overspeed.Here is the guide on how to solve Perkins 1106D generation E362 engine overspeed error.

 

Preparations:

Perkins EST 2024A & 2023A & 2019A Software Free Download

Perkins SPI2 2018A EPC+Service Manual Free Download

Perkins Communication Adapter 3

 

 

Conditions Which Generate This Code:
The engine speed is above the trip point for engine overspeed. Refer to Table.
Note: This event code represents an event. This does not represent an electronic system fault.

Note: The electronic service tool can be used to change the trip points for engine overspeed.

System Response:
The event code will be logged.
The event may be viewed by using a display module or by using the electronic service tool.

Possible Performance Effect:
E362-1
The warning lamp will be illuminated and the diagnostic lamp will flash the event code.
The fuel injection will be switched OFF until the engine speed drops below the trip point by 200 RPM.
E362-3
The warning lamp and the shutdown lamp will be illuminated and the diagnostic lamp will flash the event code.

 

If the

This Post: Perkins 1106D Generation E362 Engine Overspeed Error Solution From ChinaOBD2 Official Blog
Please keep this link if you copy the post!