This instruction show you guide on how to fit and remove Speedi-Sleeve for Perkins 1000 series engine.
Related Contents:
Newest Perkins EST 2022A & 2019A Full Support Free Download
Perkins SPI2 2018A EPC+Service Manual Free Download
Procedures:
1 Clean the crankshaft palm and remove burrs or rough areas from the palm.
2 Ensure that the sleeve (B1) is clean. Apply a narrow bead of Loctite 518 around the bore of the sleeve 5 mm (0.2 in) from the front face of the flange.
Note: The sleeve must be fitted not more than five minutes after the Loctite has been applied.
3 Ensure that the crankshaft is fully forward. Use a suitable adaptor and a hammer to drive carefully the sleeve onto the crankshaft palm. The sleeve must be fitted with a clearance of 0,4/0,6 mm (0.016/0.024 in) between the rear face of the cylinder block and the front face of the sleeve flange, dimension
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!