Paccar EPA13 All MX Engine Evaluate NOx Sensor Test by JPRO

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Here is the instruction show you guide on how to use JPRO to perform evaluate NOx sensor test for Paccar EPA 13 all MX engines.

Related Contents:

2024 JPRO Noregon Commercial Fleet Diagnostics Free Download

Noregon JPRO DLA+ 2.0 Adapter

The Evaluate NOx Sensors Test is supported on:
✓ Paccar EPA 13 all MX engines.
This test is used to verify the accuracy and functionality of the SCR system’s NOx sensors.
The tip of the NOx sensor will become extremely hot during the test and must be suspended away from anything flammable or sensitive to heat.
1 Select the Evaluate NOx Sensors Test and press Enter or click the Start button.
2 The test dialog will be displayed.

3 Select the sensor to test and click the Start button to begin the test.
4 The Start button will change to a Stop button and the lamp next to the button will indicate the test is Running.
5 During the procedure, the status is monitored and updated in the Status window. The NOx sensor will heat for approximately 10 minutes before sensor evaluation.
6 Select the Stop button to stop the test at any point.
7 Once the test has been completed, click the Exit button. A warning to allow the NOx sensor to cool before reinstallation is displayed. Click OK to return to the test selection dialog.

More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide

This Post: Paccar EPA13 All MX Engine Evaluate NOx Sensor Test by JPRO From ChinaOBD2 Official Blog
Please keep this link if you copy the post!