Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This guide explains how to perform the “Install DPF” test for Paccar EPA10 to EPA13 MX engines, using JPRO, after installing either a new or cleaned Diesel Particulate Filter (DPF).
Related Contents:
2025 JPRO Noregon Commercial Fleet Diagnostics Free Download
Noregon JPRO DLA+ 2.0 Adapter
Supported Engines:
All Paccar EPA10 to EPA13 MX engines.
Overview:
The “Install DPF” test is used to reset the vehicle’s ash level to match the status of the newly installed or cleaned DPF. This procedure should only be performed after the DPF has been installed.
Steps:
Start the Test:
Select “Install DPF” and press Enter or click the Start button.
Test Dialog:
The Install DPF dialog will appear on your screen.
Select DPF Type:
Choose either “Install New DPF” or “Install Cleaned DPF” based on your installation. The relevant test information will be displayed accordingly.
View Detailed Instructions:
Click on the procedure steps to view the detailed instructions needed for a successful installation.
Check Preconditions:
Ensure all necessary conditions are met before proceeding with the installation.
Begin the Installation:
Click the Install button to start the procedure.
Key Off the Engine:
Follow the on-screen instructions to turn off the engine when prompted.
Countdown:
Once the engine is off, a countdown timer will begin.
Key On the Engine:
When the countdown finishes, follow the instructions to turn the engine back on.
Completion:
After the engine is on, you will see a message confirming that the procedure has been successfully completed.
Exit the Test:
Click the Exit button to return to the test selection menu.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
Related posts:
Resetting the Exhaust Aftertreatment System on an International EPA0710 Maxxforce 1113 Engine with JPRO
Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test Using JPRO
Conducting an Aftertreatment Injector Flow Test on Cummins ISX 12 and 15L EPA7 Engines Using JPRO Diagnostics
International A26 Engine Fuel Enable Actuator Leak Test by JPRO: Ensuring Aftertreatment System Efficiency
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Some Friends don't know how to activate win7, when they receive the diagnostic software with win7 sytem. http://www.chinaobd2.com/upload/software/win7activation.zip download this Read more
Please ensure that you choose computer systems that meet our requirements for the installation. You will find adetailed listing in Read more
Frequent oil changes are perhaps the most important procedure you can do to maintain and prolong the life of your Read more
This article show a guide on how to use G-scan2
Please keep this link if you copy the post!