Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
The new airbag control ECU is not configured. When a new airbag ECU is fitted to a car, it must be configured in order to work properly. OP-COM currently supports the coding of SAB6, and SAB8 airbag control units.This article from chinaobd2.com is about OPCOM VAXU-COM Airbag Coding Guide for Opel.
What You Need?
Newest OPCOM VAUX-COM All Version Free Download
OPCOM Clone
Since the airbag is part of the vehicle safety system, always follow the on-screen instruction.
Please, always read the repair manual of the car, and strictly follow all the given procedures!
Important: The airbag ECU can be coded only once, when it is new. After the first successful configuration, the configuration cannot be altered, or changed!
In this example, I
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Tags: cat OP-COM OPCOM program
Related Posts
Volvo PTT Calibrate Electrical Unit Pump for Volvo MACK I II III
2019.06.17
How to Use HINO DX3 Simulation Function
2023.04.20
SmartPRO 5000U-PLUS Programmer NXP Chips Support List
2023.06.9
How to Solve Volvo Tech Tool Communication Failed Error PRO10012
2024.07.28
Choosing the Right Professional OBD II Scanner: Autel MS908S Pro II vs. Launch X...
2024.01.24
Using a Diagnostic Car Code Reader You Don
2019.02.27
Detroit DDEC6 Engine Password Protection Removal by Backdoor Calculator
2023.04.3
Detroit GHG14 Engine DOC Inlet Temperature Unable to Reach HC Dosing Solution
2023.06.13
How to Install the software of Iprog+ Programmer Iprog Pro Programmer?
2019.04.28
Yanhua ACDP2 Correct Mileage for Toyota R7F714xx ODO/Buick BCM (NEC3558)
2024.12.24