OBDSTAR X300DP Plus Read Continental PCR2.1 Immo Data with P003 Adapter

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

IMMO programming of Volkswagen, Audi, Sitte and Skoda series models, obtaining the CS, PIN CODE and MAC values of the current vehicle first is a must. Some models need to read IMMO data from the engine system, but for those models equipped with Continental PCR2.1 engine can not directly read the engine data through OBD diagnostic seat at present. Thus, OBDSTAR has developed a way to read the IMMO data of Continental PCR2.1 through bench mode using P003 adapter.

OBDSTAR P003 Kit Overview:

Diag cable OBD connector(male)
Connect P003 connector(female)
P003 adapter
Boot jumper(spring needle)
Boot jumper(welding)
ECU pin connector
ECU boot connector
12V power

OBDSTAR X300DP Plus read PCR2.1(TC1796) reading IMMO data with P003 Steps:

Please Keep the OBDStar X300DP Plus in Charging and communication in the whole process.

Open the OBDSTAR X300DP Plus Table, Choose ECU Flasher

Choose CONTINENTAL V30.00

Manual Select System

Choose CONTINENTAL PCR2.1(TC1796)(BENCH)

Read IMMO Data

Click{Bench Mode Wiring} in lower left to check wiring diagram, and connect P003 adapter with main cable and ECU Bench cables. And connect ECU Bench cables with continental PCR2.1 ECU

according to wiring diagram.