OBDSTAR X300 Classic G3 Read and Write Benz CPC2.4 ECM by BOOT

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

OBDSTAR X300 Classic G3 can read and write Mercedes-Benz CPC2.4 TC1793 ECM with MP001 and BOOT mode. 120Ω Resistor is required to connect. Ensure the network connection is normal and the 12V power supply is connected well during the operation.

Preparation:

Mercedes-Benz CPC2.4 ECM

Bench-A V3 Clone Jumper

MP001 Programmer

120Ω Resistor

Main cable

12V/5A Power Supply (DC)

OBDSTAR X300 Classic G3 Key Programmer

Operation guide:

Select ECU Flasher>> ECM>> ECM software (i.e.V30.90)>> cpc>> BENZ DELPHI CPC2.X TC1793

Check the Boot and PIN diagrams

BENZ DELPHI CPC2.X TC1793 Pinout diagram to OBDSTAR G3:

ECU	TOOL
C-Pin 2, 3	12V (16)
A-Pin 18	12V (16)
C-Pin 4	GND (4+5)
A-Pin 27	CAN L (14)
A-Pin 11	CAN H (6)

Solder according to the wiring diagram

Then connect OBDSTAR MP001 Programmer, Benz ECM and X300 Classic G3 properly, need to connect the 120Ω Resistor as well

After connection, select BOOT and MP001 mode and perform the read and write operations.

Connect ECU

Read INT Flash (TC1793) and save data

Read INT EEPROM (TC1793) and save data

Write the original INT Flash and EEPROM data into the new Benz ECM

All read and write operations are complete, disconnect the ECU.

www.chinaobd2.com

This Post: OBDSTAR X300 Classic G3 Read and Write Benz CPC2.4 ECM by BOOT From ChinaOBD2 Official Blog
Please keep this link if you copy the post!