OBDSTAR DC706 Clone BOSCH ME17.8.8 ECM on Bench

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Confirmed! OBDSTAR DC706 ECU Tool read and write BOSCH ME17.8.8 ECM by bench successfully!

It’s very easy and fast to operate with the operation guide and PINOUT in the device software.

OBDSTAR P003 Adapter, ECU Bench cables and OBD cable are required to connect DC706 ECU Tool and ECM.

Keep DC706 charging and communicating during the process, and make sure the internet connection is normal.

Operation process:

Select ECU Flasher>> All>> ECM>> ECM V30.23>> ECU Brand>> BOSCH

Input me17 in the search box to quickly find out the ECM model- BAIC BOSCH ME17.8.8 TC1728 (BENCH+ P003)

Tap “Pinout” to view the wiring diagram and follow it to connect OBDSTAR DC706 tablet, P003 Adapter Kit and ME17.8.8 ECM correctly

After connecting, tap “Start” to enter the operation interface

Connect ECU successfully

Read and back up original INT EEPROM data

Read and back up original INT Flash data

Connect OBDSTAR DC706 to a new Bosch ME17.8.8 ECM

Select the corresponding INT EEPROM and INT Flash files just saved to write into the new ECM

All read and write operations are completed.

Disconnect!

Foxflash also can support Bosch ME17.8.8 TC1728 via bench/boot/OBD.

CG FC-200 (V1.0.8.0 or above) supports ME17.8.8 on bench.

This Post: OBDSTAR DC706 Clone BOSCH ME17.8.8 ECM on Bench From ChinaOBD2 Official Blog
Please keep this link if you copy the post!