Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Adaptive Light Control modules, also known as Stepper Motor Controllers (SMC), are coded to operate specifically for the vehicle and side they are installed in. Thus, installing used ALC modules could result in directional aiming in the opposite direction of steering travel than is
expected. Recoding them into their new position first requires that they be reset; otherwise,recoding them may have no effect.
Preparation:
NCS Expert BMW Coding Software Download
INPA/EDIABAS K+DCAN USB Diagnostic cable.
BMW Coding/Flashing/Progrmming PDF+Video Guide
The procedures described herein were conducted with NCS Expert Tool version 4.0.1 running under Windows 7 x64. Vehicle was a 2008 335i Sport Sedan AT with FRM2 module standard,firmware version FRM2_E89.C09. The LSMC and RSMC modules coded had firmware version
SMCDS_LI.CO7 and SMCDS_RE.CO7 respectively.
Resetting ALC (SMC) Modules
1.Launch NCS Expert Tool, and from the menu bar choose File -> Load Profile menu
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!