This instruction show you guide on how to remove crankcase ventilation for MTU 4000 12-16V diesel engine.
Related Contents:
MTU DiaSys 2.73 2.72 Engine Diagnostic Software Free Download
Procedures:
Release clamps (1) and fit rubber sleeve (3 ) over remaining pipe end (2).
Note:Dismantling refers to engine side, left and right.
Release clamps (2) and fit rubber sleeve (1) over remaining pipe end (3).
Remove piping system.
Note:Dismantling refers to engine side, left and right.
Release clamps (arrow) and fit rubber sleeves over remaining pipe.
Unscrew hex screws (2), remove clamps with oil separator (1) and spacer sleeves.
Unscrew hex sockets (1) and remove piping system (2), left engine side.
Unscrew hex sockets (1) and remove piping system,right engine side.
Disconnect piping system (2) at T-piece.
Remove pipe clamp halves (1), disconnect line (3) at partition area (4) and remove.
MTU DiaSys 2.73 Diagnostic Software Installation Service
Remove pipe clamp halves (2), disconnect line (1) at partition area to oil pan and remove.
Unscrew hex screw (1), withdraw sleeve (2) from oil separator and remove.
Note: Sleeve is not included in scope of delivery of new oil separator.
Note: After removal, seal all connections with suitable plugs.
More repair case for MTU engine,please refer to:MTU Engine Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!