The airbag and steering wheel removal is required for a few repairs, including the steering column switches. When you remove the driver airbag, it is important you disconnect the battery and wait at least 30 minutes for any residual electricity in the system to dissipate. Make sure your steering wheel is centered and the front wheels are pointing straight ahead before you disconnect the battery.
Applies to:C350 (2007-14), C180 (2007-14), C200 (2007-14), C230 (2007-14), C250 (2007-14), C280 (2007-14), C300 (2007-14), C320 (2007-14)
Time: 1 hour
Tab: $0
Talent: 2
Tools: T30 Torx driver, 10mm Allen, breaker bar
Parts Required: Steering wheel, driver airbag
Hot Tip: Be sure to disconnect the battery and wait 30 minutes
Performance Gain: Access to components behind steering wheel
Complementary Modification: Replace steering wheel with upgraded model
Steering Wheel Airbag Removal Procedures:
Disconnect the negative battery cable (red arrow).Make sure it cannot make accidental contact with the battery,and allow 30 minutes for all the electricity to dissipate out of the vehicle.
With the wheels centered lower the steering wheel to the midway point and move it as for forward as possible (red arrow).
There are two access holes for the T30 Torx screws that hold the airbag to the steering wheel.They are located at approximately three and nine o
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!
Related Posts
Scania SDP3 2.54.2 Free Download and Installation Guide
2023.06.9
How to Remove Temperature Sensor for MTU 12-16v Engine
2024.08.10
How to Remove and Install PCU for HINO J05 Engine
2024.08.26
How to Setup CAT ET Work with Nexiq USB Link2
2023.05.13
Toyota Servo Motor Initialization by Launch X431
2019.02.27
Doosan ISUZU 6UZ1 Engine Lost Communication with TCM U0101 Solution
2023.04.17
How to Disable Secure Boot for Windows 10 Operations System
2023.04.4
Volvo PTT Export Sensor Values to Excel for Pre-2013OBD
2019.07.24
How to Setup Communication for Doosan e-Doctor EDIA Software
2024.02.25
What Scania VCI3 Interface Light Lamps Indicate?
2023.04.3