This article show a guide on how to use FVDI do offline replacement for Mercedes Benz 722.9 VGS.There big thanks to MHH forum members selfless share!!!
Procedures:
Your machine must be offline enabled and flash data mounted!!!!
Read out/save SCN coding and EHS# from vehicle using OBDII connector
Printout your control unit version page
Set up virgin vgs to fvdi on bench using the obd connector according to the following:
1.12v to pin 16 on OBD and pin 4 on ETC
2.CAN HIGH pin 6 on OBD->>>pin 1 on ETC
3.CAN LOW pin 14 on OBD—>>>pin 2 on ETC
4.Signal GROUND pin 5 on OBD—->>>>pin 5 on ETC
5.Chassis GROUND pin 4 on OBD—–>>>ground on power-supply
Transfer SCN coding and EHS# you saved into the virgin VGS
—>Replace VGS
—>Plug in old control module to car(I let it hang from connector)
—>Go into development data in ETC->control unit adaptations->Read coding and/or transfer download data to new control unit
—>follow the next steps(it will say that not all coding can be exchanged….(its ok) after you plug back in and it transfers coding it will say not all data could be exchanged, do you want to do manual settings now? say later/NO
—>On main ETC page
—>control unit version, make sure your EHS# matches the original from the control unit version page you printed out, just the EHS# must match, If it does not match goto
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!