How to solve Massey Ferguson Tractor 6700 trouble codes SPN 94, FMI 3, Fuel main filter inlet pressure sensor voltage above normal or open circuit
Preparations:
AGCO EDT 2024
AGCO 2×4 CANUSB
Description
The measured fuel filter pressure signal is above the normal operating range (> 4,6 V).
Possible causes are:
The fuel filter pressure sensor wiring is defective.
The fuel filter pressure sensor power supply is not correct.
The fuel filter pressure sensor is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 1). The CAN message indicates active fault. Engine functions that depend on the fuel filter pressure are not active.
Solution
First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the fuel filter pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).
Check the 5 V power supply to the sensor.
Check the operation with another fuel filter pressure sensor to see if the fuel filter pressure sensor is defective.
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!