Launch X431 Virgin (Erase) Mercedes-Benz ECU/TCU Feedback

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Here is a collection of Launch X431 tools tested and verified to work 100% with Mercedes-Benz ECU and TCU on the bench. Each tool includes the necessary wiring diagrams in the software, simplifying the job. Used Mercedes-Benz ECUs can be reused after resetting. Once cleared, the ECU or TCU can be installed in another vehicle and reprogrammed, coded, and personalized as needed.

1. Launch X431 PAD V with X-Prog3: Supports virginizing Benz ME9.7/TCU 722.9, MED17.7.x, SIM271DE2.0, and SIM271KE2.0 – OK

2. Launch X431 IMMO Elite/X431 IMMO Plus with X-Prog3: Supports virginizing Benz CR3.xx, C4R4.xx, CR5.xx, CR6.xx, CR60.xx, CRD.11, CRD2.xx, CRD3.xx, MED2.8.1, ME9.7 – OK

3. Launch X431 IMMO Elite/IMMO Plus with X-Prog3: Supports virginizing Benz ISM/DSM/ESM – OK

4. Launch X431 ECU & TCU Programmer: Supports virginizing Benz VGS3 – OK

Two connection methods: read in the car or remove and read.

After reading and saving EEPROM data, new data must be written (contact customer service for assistance).

5. Launch X431 X-Prog3 with PC Adapter: Supports virginizing Benz VGS3 – OK

Operation procedures are the same as with the X431 ECU Programmer.

This Post: Launch X431 Virgin (Erase) Mercedes-Benz ECU/TCU Feedback From ChinaOBD2 Official Blog
Please keep this link if you copy the post!