Launch X431 Perform ECU Coding for VW Models

Posted on by VCDS
Launch X431 Perform ECU Coding for VW Models

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

ECU code is a trigger data of in-vehicle unit. Each control unit has a relevant code, and the same model has different configures and codes. For example, the codes for two airbags are different form that for four airbags when installing. If you programme the code of two airbags installed to the control unit of four airbags, the two airbags may not be triggered.

Launch X431 Perform ECU Coding for VW Models

When need to code control unit? After installing control unit, “Control Unit Code” may be stored in ECU, but you should perform coding operation again. If you don’t do that, vehicle running malfunctions may be present, such as accelerating fault, in-gear malfunction, and engine rough running. Malfunction indicator is off when these occur. You can not check trouble codes through a scanner. Please check if ECU code is error. Trouble code will cause: bleeding value high and shifting impact, enlarging A/T load,the implausible trouble codes are stored in malfunction memorizer.

 

More Launch X431 Test Case check here:How to use Launch X431

 

Operation on coding ECU:

1.Select systems, e.g. ABS?AT?SRS.

2.Enter

How useful was this post?

Click on a star to rate it!

Average rating / 5. Vote count:

This Post: Launch X431 Perform ECU Coding for VW Models From ChinaOBD2 Official Blog
Please keep this link if you copy the post!

Tags:

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *