Launch X-Prog3 PC Adapter Clone MED9.6.1 Engine Computer on Bench

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Confirmed! Launch X431 GIII X-PROG3 key programmer with PC Adapter read and write MED9.6.1 engine computer on bench successfully.

Here is the operation process:

1.Connect devices

Connect the X431 X-PROG3 PC ADAPTOR to the computer using a cable, and then connect to G3.

Supply power to X-prog3 PC Adapter as well.

2.Obtain ECU model

Run X-PROG3 PC Adaptor software, input med9.6.1 in the search box to quickly query the desired ECU

The corresponding search result:

Buick Enclave2008-2017 3600 V6 300 MED9.6.1

3.Connect device and ECU

Double-click the ECU

Select Bench mode and go to next step

Check the connection diagram and follow it to connect Launch X-PROG3 PC Adaptor and MED9.6.1 engine computer via the bench cable correctly

4.Backup original engine computer data

Connect>> Read complete data>> Disconnect

5.Backup new engine computer data

Connect>> Read complete data

6.Write original data to new ECU

Select the original engine computer data and write it into the new one

All read and write operations are successful. Finally, disconnect the ECU.

Alright! Launch X-431 X-PROG3 PC Adapter with GIII clone MED9.6.1 engine computer perfectly.

Launch X431 ECU & TCU programmer also can perform the same function well.

This Post: Launch X-Prog3 PC Adapter Clone MED9.6.1 Engine Computer on Bench From ChinaOBD2 Official Blog
Please keep this link if you copy the post!