Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
Here is the instruction show you guide on how to mounting and remove compressor for Kubota U48-4 and U55-4 excavator.
Preparations:
2022 Kubota Takeuchi Diagmaster v22.08.01 v4.1.2 Software Free Download
Kubota DST-i Diagnostic Adapter
Kubota EPC Spare Parts Catalogue 2021.06 Download
Procedures:
(When removing)
1 Collect the refrigerant from the AC system.
2 Disconnect the negative (-) cable from the battery and the 1P connector of the magnetic clutch.
3 Remove the low-pressure pipe and the high-pressure pipe from the compressor, then immediately cap them so no water or moisture gets into the AC system.
4. Remove the AC drive belt and then the compressor.
(When attaching)
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!