Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation
This instruction show guide on how to adjust neutral for Kubota L330 L3901 L4701 excavator.
Related Contents:
2024 Kubota Takeuchi Diagmaster v24.01.06 Software Free Download
Kubota EPC Spare Parts Catalogue 2021.06 Download
Kubota DST-I Diagnostic Tool
CAUTION
• Stop the engine when adjusting the HST neutral.
1. Set the cruise control lever to “OFF” position. (HST pedal is in Neutral position.)
2. Check to see that the length a of HST control rod (2) and the length b of neutral rod (6) are specified length.
If not, adjust as follows.
Length “a”: 231.2 to 232.2 mm (9.07 to 9.11 in.)
Length “b”: 138.5 to 139.5 mm (5.49 to 5.53 in.)
3.Loosen the hex. head screw (3) to make situation that HST control lever (4) moves freely. Operate the engine for 5 seconds to make sure that the HST is in neutral position.
4. Tighten the hex. head screw (3) so that the HST control lever (4) does not turn.
NOTE
• Be sure to tighten the hex. head screw with specified torque
More repair case for Kubota,please refer to:Kubota Trouble Repair
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!