KT200 ECU Programmer Read and Write VW EDC 16U1 Eeprom

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

KT200 ECU Programmer Read and Write VW EDC 16U1 Eeprom Tutorials:

Firstly: Connec KT200 ecu programmer with VW EDC 16U1 ECU and computer, make the ECU Power is on.

Click KT200 software on the laptop, click select driver, choose Volkswagen-MPC555/6-VAG-EDC16U1

Check ECU Pinout Information, make sure the connection is correct.

Then Read Eeprom, make sure the ECU power on, save the file as name:”edc16u1 ee”

End of read, turn the dashboard off.

Reading Eeprom sucessfully and save the file.

Last step: Write Eeprom, Power on the dashboard and click write Eeprom with the file:“edc16u1 ee”
When get the note: turn the dashboard off and wait, Turn off the dashboard again.

Click Ok, Writing Sucessfully.

Video Guide:

Learn more:

KT200 Master Version(Full Version): https://www.chinaobd2.com/vp-kt200-ecu-programmer-master-full-version.html
KT200 Auto Version(Basic Version): https://www.chinaobd2.com/vp-kt200-ecu-programmer-auto-version.html

This Post: KT200 ECU Programmer Read and Write VW EDC 16U1 Eeprom From ChinaOBD2 Official Blog
Please keep this link if you copy the post!