This instruction show you guide on how to use Launch X431 to program tire pressure sensors for Jeep Compass 2008.And for more projects on Jeep,please check here: Jeep Trouble Repair.
What You Need?
Jeep Compass TPMS
Launch X431 Pro
Note:
1.Switch on the ignition.
2.Keep the battery voltage not less than 11.0V.
Operation Procedure:
1.Select Jeep V30.00 above
2.Select Kreisler 16Pin connector
3.Select manual selection
4.Select Jeep
5.Select 2008 (VIN 10th)
6.Select COMPASS
7.Select WCM (wireless control module)
8.Tire pressure sensor ID programming function(Left-Front ,Left-Rear?Right-front,Right-Rear pressure sensor ID programming)?Select
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!