After replace tire pressure monitor sensor,you need to do programming.So here i will show you guide on how to use Launch X431 Pro to do TPMS programming for Jeep Cherokee 2015.For more project on Jeep,please check here:Jeep Trouble Repair.
What You Need?
Jeep Cherokee TPMS
Launch X431 Pro
Note:
1.Switch on the ignition?
2.Keep the vehicle battery voltage not less than 11.0V.
Operation Instructions
1) Select Jeep software V30.21 above?
2) Select 16PIN connector;
3) Select manual selection
4) Select Jeep
5) Select 2014 (VIN 10th)?Actual 2015???
6) Select Cherokee
7) Select RFH (Hub)
8) Select
How useful was this post?
Click on a star to rate it!
Average rating / 5. Vote count:
Please keep this link if you copy the post!