JCB Tier 4 Intake Manifold 1 Air Temperature Sensor Voltage Error Solution

Diagzone Xdiag Subscription Renew, LAUNCH LTR-01 RF Sensor, Thinkdiag Renew , Scania SDP3 Installation

Here is the instruction show you guide on how to solve JCB Tier 4 engine K4735 SPN 1132, FMI 3, Intake manifold 1 air temperature sensor voltage above normal or open circuit.

Related Contents:

WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download

2024 JCB ServiceMaster 4 v24.6.2 Free Download for Win 10 Win11

2017 JCB Parts Plus+ and Repair Service Manual Free Download

Description

The measured intake manifold 1 temperature signal is above the normal operating range.

Possible causes are:

The intake manifold temperature sensor wiring is defective.

The intake manifold temperature sensor is defective.

Reaction in EEM

The FC is stored and the warning lamp is activated. Engine power will be reduced (Degradation Level 1). The CAN message indicates active fault.

Solution

First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:

Check the intake manifold temperature sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).

Check the operation with another intake manifold temperature sensor to see if the temperature sensor is defective.

More repair case for JCB,please refer to:JCB Trouble Repair

This Post: JCB Tier 4 Intake Manifold 1 Air Temperature Sensor Voltage Error Solution From ChinaOBD2 Official Blog
Please keep this link if you copy the post!